I have this topic here because some of Aerospace control modules are built by using NI LabView . It's a simple GUI programming language.
Front panel - User interface panel.
Block diagram - Contains graphical source code.
You can try to make your own program from the basics, like adding two numbers, etc. You will love it.
Example:
I have built a model to control temperature and pressure levels in a Tank (can be fuel tank), the system LED will blink if the levels are higher than the recommended. Blinking of LED is controlled by Boolean conditions.
Temperature ==> Ranges between 20-300 degree Celsius
Pressure ==> ranges between 0-20 MPa
Condition:
LED for Temperature will blink if the value is above 200C
LED for Pressure will blink if the value is above 10MPa
LED will remain GREEN if the levels are below the critical values.
LabView has loop as well, but WHILE loop is used and "Iteration" shows how many times the loop has run.
Front panel:
Block diagram: Source code
-
- Active Topics
-
-
- by Eli 1 hour ago Shared photos or images View the latest post Replies 6 Views 1438
- by Eli 1 day ago Re: What is in Your Mind? View the latest post Replies 728 Views 322798
- by Eli 2 days ago Dr Wahome: How World Health Organization (WHO) is Doing Bad Things View the latest post Replies 1 Views 52
- by Eli 3 days ago Introduction to Abstract Algebra View the latest post Replies 4 Views 10964
- by Eli 4 days ago All in One: YouTube, TED, X, Facebook and Instagram Reels, Videos, Images and Text Posts View the latest post Replies 333 Views 50277
- by Eli 4 days ago Generating SSH Key and Adding it to the ssh-agent for Authentication on GitHub View the latest post Replies 2 Views 1140
- by Eli 6 days ago Russia Invades Ukraine View the latest post Replies 668 Views 256283
- by Eli 1 week ago How AI Could Empower any Business View the latest post Replies 1 Views 235
- by Eli 1 week ago Pondering Big Cosmology Questions Through Lectures and Dialogues View the latest post Replies 35 Views 62094
- by Eli 1 week ago The U.S - China Rivalry, Taiwan and Hong Kong View the latest post Replies 1 Views 324
-
Modeling simple SCADA system using LabView
-
- Expert Member
- Reactions: 23
- Posts: 55
- Joined: 7 years ago
- Has thanked: 14 times
- Been thanked: 28 times
- Contact:
- Attachments
-
- simulation1.gif
- (11.17 MiB) Not downloaded yet
- simulation1.gif
- (11.17 MiB) Not downloaded yet
-
- Capture.PNG
- (21.03 KiB) Not downloaded yet
- Capture.PNG
- (21.03 KiB) Not downloaded yet
0
Last edited by Joseph Bundala on Sun Jun 25, 2017 1:53 pm, edited 2 times in total.
-
- Expert Member
- Reactions: 23
- Posts: 55
- Joined: 7 years ago
- Has thanked: 14 times
- Been thanked: 28 times
- Contact:
Exactly, example in case of higher temperature then PLC will start a fan, cooling gas, or any means set for cooling the system.
SCADA<==>PLC<==>ACTUATORS
Actuators are physical phenomenons like motors, etc.@gaDgeT
SCADA<==>PLC<==>ACTUATORS
Actuators are physical phenomenons like motors, etc.@gaDgeT
0
-
- Information
-
Who is online
Users browsing this forum: No registered users and 0 guests